PT-screw
for fastening of thermoplastics
O no inserts needed
O higher pull-out load
O higher safety against over tightening or cracking of the boss.
Due to variable properties of the plastic and hole tolerance in the boss, the tightening torques may vary. It is strongly recommended to test on prototypes or similar parts to determine hole diameter and depth of the boss. PT-screws should be tightened with torque controlled drivers. For safer joints and best assembly practices, ask our technical specialists for assistance. Production range
PT oval head screws, type H (Phillips)
steel, case-hardened
Zinc plated WN 1412-A
Zinc plated PT hexalobular socket
pan head screws Torx ?plus, steel, case-hardened
WN 1452
Zinc plated type H (Phillips), steel, case-hardened
WN 1413-A
Zinc plated with pressed-on washer, type H (Phillips), steel, case-hardened
WN 1411-A