}Rev.2/Add.118/Amend.2
E/ECE/324
E/ECE/TRANS/505
7 August 2008
AGREEMENT
CONCERNING THE ADOPTION OF UNIFORM TECHNICAL PRESCRIPTIONS FOR WHEELED VEHICLES, EQUIPMENT AND PARTS WHICH CAN BE FITTED AND/OR BE USED ON WHEELED VEHICLES AND THE CONDITIONS FOR RECIPROCAL RECOGNITION OF APPROVALS GRANTED ON THE BASIS OF
THESE PRESCRIPTIONS /
(Revision 2, including the amendments that entered into force on 16 October 1995)
_________
Addendum 118: Regulation No. 119
Amendment 2
Supplement 2 to the original version of the Regulation - Date of entry into force: 11 July 2008
UNIFORM PROVISIONS CONCERNING THE APPROVAL OF CORNERING
LAMPS FOR POWER-DRIVEN VEHICLES
_________
UNITED NATIONS
?/ Former title of the Agreement:
Agreement Concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts, done at Geneva on 20 March 1958.
GE.08-
E/ECE/324
}Rev.2/Add.118/Amend.2
E/ECE/TRANS/505
Regulation No. 119
page 2
Insert a new paragraph 1.3., to read:
"1.3. References made in this Regulation to standard (étalon) filament lamp(s) and to Regulation No. 37 shall refer to Regulation No. 37 and its series of amendments in
force at the time of application for type approval."
Paragraph 2.2.2., amend to read:
"2.2.2. a brief technical description stating, in particular, with the exception of lamps with non-replaceable light sources:
(a) the category or categories of filament lamp(s) prescribed; this filament lamp
category shall be one of those contained in Regulation No. 37 and its series of
amendments in force at the time of application for type approval; and/or
(b) the light source module specific identification code."
Insert new paragraphs 5.4. to 5.4.3., to read:
"5.4. In the case of replaceable filament lamp(s):
5.4.1. Any category or categories of filament lamp(s) approved according to
Regulation No. 37 may be used, provided that no restriction on the use is made in
Regulation No. 37 and its series of amendments in force at the time of application for
type approval.
5.4.2. The design of the device shall be such that the filament lamp can be fixed in no other
position but the correct one.
5.4.3. The filament lamp holder shall conform to the characteristics given in IEC
Publication 60061. The holder data sheet relevant to the category of filament lamp
used, applies."
-----