Confidential. All rights reserved. No part of this document may be transmitted or reproduced without prior permission of a Standards Department of the Volkswagen Group.
Parties to a contract can only obtain this standard via the B2B supplier platform “https://www.sodocs.net/doc/933205135.html,”.
VOLKSWAGEN AG
F o r m F E 41 - 01.05
T h e E n g l i s h t r a n s l a t i o n i s b e l i e v e d t o b e a c c u r a t e . I n c a s e o f d i s c r e p a n c i e s t h e G e r m a n v e r s i o n s h a l l g o v e r n .
Page 2
PV 3905: 2005-09
4 Aging and test conditions
Aging duration (22 ± 2) h; aging temperature according to applicable Technical Supply Specification (TL standard) and/or drawing:
─(-30 ± 1) °C for components used in the vehicle interior (e. g. dashboard, door trim panels, carpets) and exterior add-on parts (e. g. bumper, plastic fender).
─(-40 ± 1) °C for safety-relevant components (e. g. chassis, fuel tank)
Ball-drop height: 230 mm. Deviations from aging temperature and ball-drop height according to TL standard and/or drawing.
Aging starts with inserting the ball-drop device prepared for testing into the test room conditioned at aging temperature, and ends with the ball drop at aging temperature after the specified aging duration.
5 Test
report
The following shall be specified in the test report:
1. Aging duration and aging temperature
2. Ball drop height
3. Additional or deviating test conditions
4. Findings
Figure 1 – Test equipment Legend
1 Stainless steel ball,
? (50.0 ± 0.03) mm, (500 ± 5) g
2 Guide tube, smooth on the inside,
? (53.0 + 0.5) mm, with slots for ball holder 3 Ball holder, mechanically or electro-
mechanically removable
4 Contact surface corresponding to a load per
unit area of approx. 50 g/cm2
5 Specimen, protruding ≥ 5 mm over the tube
contact surface
6 Al base plate, with (10 ± 0.5) mm recess
and ? (50.0 ± 0.5) mm, upper edge radius
r = 1